/etc/init.d/enable-nat is in debian-edu-config 1.818+deb8u2.
This file is owned by root:root, with mode 0o755.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 | #! /bin/sh
### BEGIN INIT INFO
# Provides: enable-nat
# Required-Start: $remote_fs
# Should-Start: $network $syslog
# Required-Stop: $remote_fs
# Should-Stop: $network $syslog
# Default-Start: 2 3 4 5
# Default-Stop: 0 1 6
# Short-Description: Enabling NAT for clients behind eth1
# Description: Enabling Network Address Translation for clients
# sitting in the thin client network behind eth1
### END INIT INFO
IPTABLES=/sbin/iptables
NETWORK_TO_NAT=
OUTSIDE_IF=eth0
# Only enable by default if LTSP is installed
if [ -e /opt/ltsp ] ; then
NETWORK_TO_NAT="192.168.0.0/24"
fi
. /lib/lsb/init-functions
if [ -f /etc/default/enable-nat ] ; then
. /etc/default/enable-nat
fi
# Bail out if no iptables binary or no configuration
[ -x ${IPTABLES} -a "$NETWORK_TO_NAT" ] || exit 0
do_status() {
$IPTABLES -L -t nat |grep -A3 POSTROUTING
}
is_enabled() {
if do_status | grep -q "$NETWORK_TO_NAT" ; then
true
else
false
fi
}
do_start() {
if is_enabled ; then
log_action_msg "NAT for clients on network $NETWORK_TO_NAT already enabled"
else
log_action_begin_msg "Enabling NAT for clients on network $NETWORK_TO_NAT."
$IPTABLES -t nat -A POSTROUTING -s $NETWORK_TO_NAT -o $OUTSIDE_IF -j MASQUERADE
log_action_end_msg $?
fi
# Enable IP-forwarding if it isn't enabled already.
if [ 0 = "`cat /proc/sys/net/ipv4/ip_forward`" ]; then
log_action_begin_msg "Enabling IPv4 forwarding."
echo 1 > /proc/sys/net/ipv4/ip_forward
log_action_end_msg $?
fi
}
do_stop() {
if is_enabled ; then
log_action_begin_msg "Disabling NAT for clients on network $NETWORK_TO_NAT."
$IPTABLES -F -t nat
log_action_end_msg $?
else
log_action_msg "NAT for clients on network $NETWORK_TO_NAT already disabled"
fi
}
case "$1" in
start)
do_start
;;
stop)
do_stop
;;
restart|force-reload)
do_stop
do_start
;;
status)
do_status
;;
*)
echo "Usage: $0 {start|stop|restart|force-reload|status}"
exit 2
;;
esac
exit 0
|