/etc/laptop-mode/conf.d/ethernet.conf is in laptop-mode-tools 1.66-2.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 | #
# Configuration file for Laptop Mode Tools module ethernet.
#
# For more information, consult the laptop-mode.conf(8) manual page.
#
###############################################################################
# Ethernet power saving settings
# ------------------------------
#
#__COMMENT There are various ways to save power with ethernet. This section allows you
#__COMMENT to control the speed of your ethernet connection, and your wakeup-on-LAN
#__COMMENT settings. Both these things can have quite a power impact if you use Ethernet.
#__COMMENT
#__COMMENT Note: Changing ethernet device speed may require link up/down on some devices.
#__COMMENT This might lead to connection to be re-initialized
#
###############################################################################
# Enable debug mode for this module
# Set to 1 if you want to debug this module
DEBUG=0
# Control Ethernet settings?
CONTROL_ETHERNET="auto"
# Handle throttling of the ethernet device under specific circumstances
BATT_THROTTLE_ETHERNET=0
LM_AC_THROTTLE_ETHERNET=0
NOLM_AC_THROTTLE_ETHERNET=0
# Speed to throttle to when throttling is set
# Please use the desired throttle value as reported by ethtool and set it accordingly
# To get the speed capacity supported by your ethernet card, as user "root" run
# "ethtool eth0", where eth0 is your physical ethernet device.
# Example:
# Set speed to 100Mbps.
# THROTTLE_SPEED=100
#
# Throttle ethernet to the lowest available speed of the ethernet device
# THROTTLE_SPEED="slowest"
#
# Throttle ethernet to the fastest available speed of the ethernet device
# This can be helpful when you want to control the speed, even when on battery
# THROTTLE_SPEED="fastest"
#
# Note: If you don't know how to find the speed of your ethernet card, leave the
# following values as it is.
THROTTLE_SPEED="slowest"
# Disable wakeup-on-LAN? This will disable wakeup-on-LAN unconditionally,
# independent of battery power. It will save power while your laptop is turned
# off or in standby mode.
DISABLE_WAKEUP_ON_LAN=1
# A list of the ethernet devices that should be controlled.
ETHERNET_DEVICES="eth0"
# In practise, most of the times a user is on battery, she is using the wireless device
# Under such cases, you might want to disable your ethernet interface completely, when
# on battery.
#
# Set below setting to 1, to disable ethernet interface when on battery and
# when no carrier is detected on the interface (e.g., no active cable is
# plugged in).
DISABLE_ETHERNET_ON_BATTERY=1
|