/usr/src/xtables-addons-2.6/extensions/pknock/libxt_pknock.man is in xtables-addons-dkms 2.6-1.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 101 102 103 104 105 106 107 108 109 110 111 112 113 | Pknock match implements so-called "port knocking", a stealthy system
for network authentication: a client sends packets to selected
ports in a specific sequence (= simple mode, see example 1 below), or a HMAC
payload to a single port (= complex mode, see example 2 below),
to a target machine that has pknock rule(s) installed. The target machine
then decides whether to unblock or block (again) the pknock-protected port(s).
This can be used, for instance, to avoid brute force
attacks on ssh or ftp services.
.PP
Example prerequisites:
.IP
modprobe cn
.IP
modprobe xt_pknock
.PP
Example 1 (TCP mode, manual closing of opened port not possible):
.IP
iptables \-P INPUT DROP
.IP
iptables \-A INPUT \-p tcp \-m pknock \-\-knockports 4002,4001,4004 \-\-strict
\-\-name SSH \-\-time 10 \-\-autoclose 60 \-\-dport 22 \-j ACCEPT
.PP
The rule will allow tcp port 22 for the attempting IP address after the successful reception of TCP SYN packets
to ports 4002, 4001 and 4004, in this order (a.k.a. port-knocking).
Port numbers in the connect sequence must follow the exact specification, no
other ports may be "knocked" inbetween. The rule is named '\fBSSH\fP' \(em a file of
the same name for tracking port knocking states will be created in
\fB/proc/net/xt_pknock\fP .
Successive port knocks must occur with delay of at most 10 seconds. Port 22 (from the example) will
be automatiaclly dropped after 60 minutes after it was previously allowed.
.PP
Example 2 (UDP mode \(em non-replayable and non-spoofable, manual closing
of opened port possible, secure, also called "SPA" = Secure Port
Authorization):
.IP
iptables \-A INPUT \-p udp \-m pknock \-\-knockports 4000 \-\-name FTP
\-\-opensecret foo \-\-closesecret bar \-\-autoclose 240 \-j DROP
.IP
iptables \-A INPUT \-p tcp \-m pknock \-\-checkip \-\-name FTP \-\-dport 21 \-j ACCEPT
.PP
The first rule will create an "ALLOWED" record in /proc/net/xt_pknock/FTP after
the successful reception of an UDP packet to port 4000. The packet payload must be
constructed as a HMAC256 using "foo" as a key. The HMAC content is the particular client's IP address as a 32-bit network byteorder quantity,
plus the number of minutes since the Unix epoch, also as a 32-bit value.
(This is known as Simple Packet Authorization, also called "SPA".)
In such case, any subsequent attempt to connect to port 21 from the client's IP
address will cause such packets to be accepted in the second rule.
.PP
Similarly, upon reception of an UDP packet constructed the same way, but with
the key "bar", the first rule will remove a previously installed "ALLOWED" state
record from /proc/net/xt_pknock/FTP, which means that the second rule will
stop matching for subsequent connection attempts to port 21.
In case no close-secret packet is received within 4 hours, the first rule
will remove "ALLOWED" record from /proc/net/xt_pknock/FTP itself.
.PP
Things worth noting:
.PP
\fBGeneral\fP:
.PP
Specifying \fB--autoclose 0\fP means that no automatic close will be performed at all.
.PP
xt_pknock is capable of sending information about successful matches
via a netlink socket to userspace, should you need to implement your own
way of receiving and handling portknock notifications.
Be sure to read the documentation in the doc/pknock/ directory,
or visit the original site \(em http://portknocko.berlios.de/ .
.PP
\fBTCP mode\fP:
.PP
This mode is not immune against eavesdropping, spoofing and
replaying of the port knock sequence by someone else (but its use may still
be sufficient for scenarios where these factors are not necessarily
this important, such as bare shielding of the SSH port from brute-force attacks).
However, if you need these features, you should use UDP mode.
.PP
It is always wise to specify three or more ports that are not monotonically
increasing or decreasing with a small stepsize (e.g. 1024,1025,1026)
to avoid accidentally triggering
the rule by a portscan.
.PP
Specifying the inter-knock timeout with \fB--time\fP is mandatory in TCP mode,
to avoid permanent denial of services by clogging up the peer knock-state tracking table
that xt_pknock internally keeps, should there be a DDoS on the
first-in-row knock port from more hostile IP addresses than what the actual size
of this table is (defaults to 16, can be changed via the "peer_hasht_ents" module parameter).
It is also wise to use as short a time as possible (1 second) for \fB--time\fP
for this very reason. You may also consider increasing the size
of the peer knock-state tracking table. Using \fB--strict\fP also helps,
as it requires the knock sequence to be exact. This means that if the
hostile client sends more knocks to the same port, xt_pknock will
mark such attempt as failed knock sequence and will forget it immediately.
To completely thwart this kind of DDoS, knock-ports would need to have
an additional rate-limit protection. Or you may consider using UDP mode.
.PP
\fBUDP mode\fP:
.PP
This mode is immune against eavesdropping, replaying and spoofing attacks.
It is also immune against DDoS attack on the knockport.
.PP
For this mode to work, the clock difference on the client and on the server
must be below 1 minute. Synchronizing time on both ends by means
of NTP or rdate is strongly suggested.
.PP
There is a rate limiter built into xt_pknock which blocks any subsequent
open attempt in UDP mode should the request arrive within less than one
minute since the first successful open. This is intentional;
it thwarts eventual spoofing attacks.
.PP
Because the payload value of an UDP knock packet is influenced by client's IP address,
UDP mode cannot be used across NAT.
.PP
For sending UDP "SPA" packets, you may use either \fBknock.sh\fP or
\fBknock-orig.sh\fP. These may be found in doc/pknock/util.
|