/usr/share/tkgate/doc/popupmenu.html is in tkgate-doc 2.0~b10-6.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 | <p>
<center>
<Table>
<Tr><Th align=left Width=170>Context</Th><Th align=left>Description</Th></Tr>
<Tr><Td>Wire</Td><Td>Popop menus for wires allow you to open the
properties box for the wire, or add a branch segment to a wire to allow
you to connect it to another gate or wire.</Td><Tr>
<Tr><Td>Gate</Td><Td>Popup menus for common gates allow you to open
the properties box for the gate, set or clear the anchor flag, or
delete the gate. </Td><Tr>
<Tr><Td>Variable Input Gate </Td><Td>For variable input gates such as
AND and OR gates, you can also add inputs through the popup menus in
addition to the standard gate functions.</Td><Tr>
<Tr><Td>Multi-Gate Selection</Td><Td>When multiple gates are selected,
you can set or clear the anchor flag for all of the gates in the
selection, or delete the entire selection.</Td><Tr>
<Tr><Td>4-Wire Joint</Td><Td>The popup menu for joint with four
attached wire contains only the anchor set/clear option.</Td><Tr>
<Tr><Td>3-Wire Joint</Td><Td>For joints with three wires attached, an
additional add wire segment option allows you to attach a wire to the
unused side of the joint.</Td><Tr>
<Tr><Td>Module</Td><Td>In addition to the standard gate functions, the
popup menu for modules also allows you to open the block, mark the
block as the standard interface for a module type, and add/change
ports to/on the module. </Td><Tr>
<Tr><Td>Canvas</td><td>Right clicking on the canvas where there are no
objects brings up a popup menu with options to close the current
module, create a gate/module or change the current tool.</td><tr>
<tr><td>Non-Move Mode</td><td> When TkGate is not in Move/Connect
mode, only the close module and change tool options are enabled
</td><tr>
<tr><td>simulation</td><td>When in simulation mode, the popup menu
allows you to use any of the simulation menu functions.</td><tr>
</TABLE>
</center>
|