/var/spool/hylafax/config/conexant-1.0 is in hylafax-server 3:6.0.6-8.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 | # $Id$
#
# Configuration for a Rockwell/Conexant K56 Class 1.0 modem using
# the RCV56DPF and similar chipsets. These chipsets are generally
# flash- upgradable and appear on ISA as well as PCI. They
# support "Class 1.0" which means that they have "adaptive receive"
# (AT+FAR=1), but not V.34.
#
# Comtrol RocketModem II/III/IV
# MultiTech MT5600ZDX
# Zoltrix FMVSP56i3
#
# CONFIG:CLASS1.0:56000:.*:.*: Manufacturer=Rockwell/Conexant Model=AC/K56
# CONFIG:CLASS1.0:MT5600ZDX:.*:.*: Manufacturer=MultiTech Model=MT5600ZDX
# CONFIG:CLASS1.0:MT5656ZDX:.*:.*: Manufacturer=MultiTech Model=MT5656ZDX
# CONFIG:CLASS1.0:.*:.*LEONARDO.*:.*: Manufacturer=Digicom Model=Leonardo
#
# BEGIN-SERVER
# END-SERVER
#
# Modem-related stuff: should reflect modem command interface
# and hardware connection/cabling (e.g. flow control).
#
ModemType: Class1.0 # use this to supply a hint
ModemRate: 19200 # rate for DCE-DTE communication
ModemFlowControl: rtscts # default
#
# With the RocketModem IV (and possibly III) you may need to use a much
# higher ModemRate than 19200 because, apparently, it suffers from potential
# buffer underrun problems. Fortunately, it doesn't have buffer overflow
# issues, and so using 115200 should work (both rtscts and xonxoff test good).
#
ModemNoFlowCmd: AT&K0 # setup no flow control
ModemHardFlowCmd: AT&K3 # setup hardware flow control
ModemSoftFlowCmd: AT&K4 # setup software flow control
ModemSetupDTRCmd: AT&D2 # setup so DTR drop resets modem
ModemSetupDCDCmd: AT&C1 # setup so DCD reflects carrier (or not)
#
Class1AdaptRecvCmd: AT+FAR=1 # reports carrier detection mismatches
|