/etc/radcli/radiusclient.conf is in libradcli4 1.2.6-4.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 | # RADIUS settings
# The name to be used to identify this NAS (server). If set it will
# be used in NAS-Identifier field and will override any such setting
# by the application.
#
#nas-identifier my-server-name
# Override the IP (or IPv6) address of the NAS.
#nas-ip 10.100.5.3
#nas-ip ::1
# RADIUS server to use for authentication requests.
# optionally you can specify a the port number on which is remote
# RADIUS listens separated by a colon from the hostname. if
# no port is specified /etc/services is consulted of the radius
# service. if this fails also a compiled in default is used.
# For IPv6 addresses use the '[IPv6]:port:secret' format, or
# simply '[IPv6]'. You may specify more than a single server
# in a comma-separated list.
#
authserver localhost
#authserver 127.1.1.1:9999,172.17.0.1
# RADIUS server to use for accouting requests. All that is
# written for authserver applies, in acctserver as well.
#
acctserver localhost
# File holding shared secrets used for the communication
# between the RADIUS client and server. When multiple
# server
servers /etc/radcli/servers
# Dictionary of allowed attributes and values. That depends
# heavily on the features of your server. A default dictionary
# is installed in /usr/share/radcli/dictionary
dictionary /etc/radcli/dictionary
# default authentication realm to append to all usernames if no
# realm was explicitly specified by the user
# the radiusd directly form Livingston doesnt use any realms, so leave
# it blank then
default_realm
# time to wait for a reply from the RADIUS server
radius_timeout 10
# resend request this many times before trying the next server
radius_retries 3
# local address from which radius packets have to be sent
bindaddr *
# Transport Protocol Support
# Available options - 'tcp', 'udp', 'tls' and 'dtls'.
# If commented out, udp will be used.
#serv-type udp
# To enable verbose debugging messages in syslog, enable the following
#clientdebug 1
|