This file is indexed.

postinst is in lm-sensors 1:3.4.0-4.

This file is a maintainer script. It is executed when installing (*inst) or removing (*rm) the package.

The actual contents of the file can be viewed below.

 1
 2
 3
 4
 5
 6
 7
 8
 9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
#!/bin/sh
set -e
# Automatically added by dh_systemd_enable
# This will only remove masks created by d-s-h on package removal.
deb-systemd-helper unmask lm-sensors.service >/dev/null || true

# was-enabled defaults to true, so new installations run enable.
if deb-systemd-helper --quiet was-enabled lm-sensors.service; then
	# Enables the unit on first installation, creates new
	# symlinks on upgrades if the unit file has changed.
	deb-systemd-helper enable lm-sensors.service >/dev/null || true
else
	# Update the statefile to add new symlinks (if any), which need to be
	# cleaned up on purge. Also remove old symlinks.
	deb-systemd-helper update-state lm-sensors.service >/dev/null || true
fi
# End automatically added section
# Automatically added by dh_installinit
if [ "$1" = "configure" ] || [ "$1" = "abort-upgrade" ]; then
	if [ -x "/etc/init.d/lm-sensors" ]; then
		update-rc.d lm-sensors defaults >/dev/null || exit $?
	fi
fi
# End automatically added section
# Automatically added by dh_installdeb
dpkg-maintscript-helper rm_conffile /etc/blacklist.d/lm-sensors 1:2.9.0-14~ -- "$@"
# End automatically added section
# Automatically added by dh_installdeb
dpkg-maintscript-helper rm_conffile /etc/modutils/i2c 1:3.0.1-4~ -- "$@"
# End automatically added section
# Automatically added by dh_installdeb
dpkg-maintscript-helper rm_conffile /etc/modprobe.d/i2c 1:3.1.0-1~ -- "$@"
# End automatically added section
# Automatically added by dh_installdeb
dpkg-maintscript-helper mv_conffile /etc/modprobe.d/lm-sensors /etc/modprobe.d/lm-sensors.conf 1:3.1.0-1~ -- "$@"
# End automatically added section
# Automatically added by dh_installdeb
dpkg-maintscript-helper rm_conffile /etc/init.d/fancontrol 1:3.1.1-5~ -- "$@"
# End automatically added section