/usr/share/perl5/auto/Inline/print_info.al is in libinline-perl 0.49-1.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 | # NOTE: Derived from blib/lib/Inline.pm.
# Changes made here will be lost when autosplit is run again.
# See AutoSplit.pm.
package Inline;
#line 1181 "blib/lib/Inline.pm (autosplit into blib/lib/auto/Inline/print_info.al)"
#==============================================================================
# Print a small report if PRINT_INFO option is set.
#==============================================================================
sub print_info {
use strict;
my $o = shift;
print STDERR <<END;
<-----------------------Information Section----------------------------------->
Information about the processing of your Inline $o->{API}{language_id} code:
END
print STDERR <<END if ($o->{INLINE}{object_ready});
Your module is already compiled. It is located at:
$o->{API}{location}
END
print STDERR <<END if ($o->{INLINE}{object_ready} and $o->{CONFIG}{FORCE_BUILD});
But the FORCE_BUILD option is set, so your code will be recompiled.
I\'ll use this build directory:
$o->{API}{build_dir}
and I\'ll install the executable as:
$o->{API}{location}
END
print STDERR <<END if (not $o->{INLINE}{object_ready});
Your source code needs to be compiled. I\'ll use this build directory:
$o->{API}{build_dir}
and I\'ll install the executable as:
$o->{API}{location}
END
eval {
print STDERR $o->info;
};
print $@ if $@;
print STDERR <<END;
<-----------------------End of Information Section---------------------------->
END
}
# end of Inline::print_info
1;
|