/usr/share/doc/libperl6-say-perl/README is in libperl6-say-perl 0.12-1.1.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 | #$Id: README 1214 2008-02-09 23:41:58Z jimk $
Perl6::Say - 'print' -- but no newline needed
This document refers to version 0.12 of Perl6::Say.
This version was released February 10, 2008.
To install this module on your system, place the tarball archive file in a
temporary directory and call the following:
% gunzip Perl6-Say-0.12.tar.gz
% tar xf Perl6-Say-0.12.tar
% cd Perl6-Say-0.12
% perl Makefile.PL
% make
% make test
% make install
If during installation you wish to view more information on test results,
substitute the following for the sixth line in the sequence of commands
above:
% make test TEST=VERBOSE
If you are installing this module over any earlier version, you may
substitute the following for the last line in the sequence of commands
above:
% make install UNINST=1
If you are installing this module on a Win32 system with 'nmake',
substitute 'nmake' for 'make' in the sequence of commands above.
In sending e-mail to the maintainer, please put "Perl6::Say",
"Perl6-Say" or "Say" in the subject line.
Original author: Damian Conway
Maintainer since July 2006 (version 0.05_002): James E Keenan
CPAN ID: JKEENAN
jkeenan@cpan.org
Dependencies: Uses only modules found in the Perl Core as of 5.007003.
For use with older Perls, see Makefile.PL.
Copyright (C) 2004 Damian Conway.
This library is free software; you can redistribute it and/or modify
it under the same terms as Perl itself.
|