/etc/apcupsd/multimon.conf is in apcupsd 3.14.10-1.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 | # Sample multimon configuration file
#
# This file is not required. Without it, multimon will use the default
# field layout.
#
# Temperature selection
#
# Pick "TEMPC" for Celsius or "TEMPF" for Fahrenheit. This will override
# the --enable-celsius setting from the compile. UPSTEMP (below) will
# use this setting by default.
TEMPC
# Format:
# FIELD <variable> "<field name>" "<field suffix>"
#
# <variable> is either a word from the UPS protocol like battchg (see the
# table in src/cgi/upsfetch.c) or a special word in uppercase.
#
# Special words are:
# MODEL - Show the model name for this system in cyan
#
# STATUS - Parse the status for this system using the appropriate color
#
# UPSTEMP and AMBTEMP use the default scale. This is set to C if you use
# --enable-celsius at compile time *or* if you use "TEMPC" above.
#
# UPSTEMP - Show the UPS temperature in the default scale (suffix ignored)
# AMBTEMP - Show the ambient temperature in the default scale (suffix ignored)
#
# UPSTEMPC - Show the UPS temperature in degrees C (suffix ignored)
# UPSTEMPF - Show the UPS temperature in degrees F (suffix ignored)
# AMBTEMPC - Show the ambient temperature in degrees C (suffix ignored)
# AMBTEMPF - Show the ambient temperature in degrees F (suffix ignored)
#
# They're called "special" since they actually understand the content
# being printed and do other things based on what's in there.
#
# <field name> is what you'd like this column to be called on the page.
# Remember that this is HTML, so you can actually embed markup in here.
# This means you can even include images here. You can include quotes
# (and backslashes!) in the string by escaping them with a backslash (\).
#
# <field suffix> is typically something like % or VAC. It's useful if
# you want to convey the units that apply to a value.
#
# Example config
FIELD SYSTEM "System" ""
FIELD MODEL "Model" ""
FIELD STATUS "Status" ""
FIELD battpct "Battery Chg" "%"
FIELD utility "Utility" "VAC"
FIELD loadpct "UPS Load" "%"
FIELD UPSTEMP "UPS Temp" ""
FIELD runtime "Batt. Run Time" "min."
FIELD DATA "Data" "All data"
# These are only useful if you have a Smart-UPS model with the Measure-UPS II
# measurement card. No other models presently support these features.
#
# FIELD AMBTEMP "Ambient Temp" ""
# FIELD HUMIDITY "Ambient Humidity" "%"
|