/usr/share/doc/ethtool/README.Debian is in ethtool 1:3.13-1.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 | ethtool for Debian
------------------
Most settings that can be controlled through ethtool can be specified
in /etc/network/interfaces. They will then be applied to interfaces
that are brought up automatically at boot time or using the 'ifup'
command. The following settings are supported:
Link mode (--change):
link-speed <speed>
link-duplex half|full
Ethernet settings (--change):
ethernet-autoneg on|off|<mask>
ethernet-port <port>
ethernet-wol <mode> [<pass-key>]
Driver control (--change):
driver-message-level <level>
Ethernet flow control (--pause):
ethernet-pause-rx on|off
ethernet-pause-tx on|off
ethernet-pause-autoneg on|off
Protocol offload (--offload):
offload-rx on|off
offload-tx on|off
offload-sg on|off
offload-tso on|off
offload-ufo on|off
offload-gso on|off
offload-lro on|off
(etc.)
Hardware tuning (--coalesce, --ring):
hardware-irq-coalesce-adaptive-rx on|off
hardware-irq-coalesce-adaptive-tx on|off
hardware-irq-coalesce-rx-usecs <n>
hardware-irq-coalesce-rx-frames <n>
(etc.)
hardware-dma-ring-rx <size>
hardware-dma-ring-rx-mini <size>
hardware-dma-ring-rx-jumbo <size>
hardware-dma-ring-tx <size>
Example:
iface eth0 inet dhcp
link-speed 100
link-duplex full
ethernet-autoneg off
ethernet-wol s 46:65:62:69:61:6e
-- Ben Hutchings <ben@decadent.org.uk>, Sat, 4 Jun 2011 20:37:08 +0100
|