/usr/share/ion/configs/loopback-ltp/loopback.bprc is in ion-doc 3.2.0~dfsg1-1.
This file is owned by root:root, with mode 0o644.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 | # bprc configuration file for the loopback test.
# Command: % bpadmin loopback.bprc
# This command should be run AFTER ionadmin and ltpadmin and
# BEFORE ipnadmin or dtnadmin.
#
# Ohio University, Oct 2008
# Initialization command (command 1).
1
# Add an EID scheme.
# The scheme's name is ipn.
# This scheme's forwarding engine is handled by the program 'ipnfw.'
# This scheme's administration program (acting as the custodian
# daemon) is 'ipnadminep.'
a scheme ipn 'ipnfw' 'ipnadminep'
# Add endpoints.
# Establish endpoints ipn:1.1 and ipn:1.2 on the local node.
# The behavior for receiving a bundle when there is no application
# currently accepting bundles, is to queue them 'q', as opposed to
# immediately and silently discarding them (use 'x' instead of 'q' to
# discard).
# Note that the custodian endpoint ipn:1.0 is automatically generated.
a endpoint ipn:1.1 q
a endpoint ipn:1.2 q
# Add a protocol.
# Add the protocol named ltp.
# Estimate transmission capacity assuming 1400 bytes of each frame (in
# this case, udp on ethernet) for payload, and 100 bytes for overhead.
a protocol ltp 1400 100
# Add an induct. (listen)
# Add an induct to accept bundles using the ltp protocol.
# The duct's name is 1 (this is for future changing/deletion of the
# induct).
# The induct itself is implemented by the 'ltpcli' command.
a induct ltp 1 ltpcli
# Add an outduct. (send to yourself)
# Add an outduct to send bundles using the ltp protocol.
# The duct's name is 1 (this is for future changing/deletion of the
# outduct).
# The outduct itself is implemented by the 'ltpclo' command.
a outduct ltp 1 ltpclo
# Start the daemons
s
|