/etc/asterisk/smdi.conf is in asterisk-config 1:13.1.0~dfsg-1.1ubuntu4.
This file is owned by root:root, with mode 0o640.
The actual contents of the file can be viewed below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 | ; Asterisk SMDI configuration
[interfaces]
; Specify serial ports to listen for SMDI messages on below. These will be
; referenced later in chan_dahdi.conf. If you do not specify any interfaces
; then SMDI will be disabled. Interfaces can have several different attributes
; associated with them.
; Set the number of stop bits to use per character here. The default is no,
; in which case one stop bit will be used.
;twostopbits = no
; Character size or bit length is the size of each character sent across the
; link. Character size can be 7 or 8. The default is 7.
;charsize = 7
; If you need parity checking enabled you can turn it on here. Acceptable
; values are even, odd, and none. The default is even.
;paritybit = even
; The baudrate to use for this port. Acceptable values are 1200, 2400, 4800,
; and 9600. The default is 9600.
;baudrate = 1200
; Often the numbering scheme for a set of mailboxes or extensions will not be 7
; or 10 digits (as SMDI requires). Use the msdstrip option to strip unused
; digits from the start of numbers.
;msdstrip = 0
; Occasionally Asterisk and the SMDI switch may become out of sync. If this
; happens, Asterisk will appear one or several calls behind as it processes
; voicemail requests. To prevent this from happening, adjust the msgexpirytime.
; This will make Asterisk discard old SMDI messages that have not yet been
; processed. The default expiry time is 30000 milliseconds.
;msgexpirytime = 30000
;smdiport => /dev/ttyS0
[mailboxes]
; This section configures parameters related to MWI handling for the SMDI link.
; This option configures the polling interval used to check to see if the
; mailboxes have any new messages. This option is specified in seconds.
; The default value is 10 seconds.
;
;pollinginterval=10
; Every other entry in this section of the configuration file is interpreted as
; a mapping between the mailbox ID on the SMDI link, and the local Asterisk
; mailbox name. In many cases, they are the same thing, but they still must be
; listed here so that this module knows which mailboxes it needs to pay
; attention to.
;
; Syntax:
; <SMDI mailbox ID>=<Asterisk Mailbox Name>[@Asterisk Voicemail Context]
;
; If no Asterisk voicemail context is specified, "default" will be assumed.
;
; Before specifying mailboxes, you must specify an SMDI interface. All mailbox
; definitions that follow will correspond to that SMDI interface. If you specify
; another interface, then all definitions following that will correspond to the
; new interface.
;
;smdiport=/dev/ttyS0
;2565551234=1234@vmcontext1
;2565555678=5678@vmcontext2
;smdiport=/dev/ttyS1
;2565559999=9999
|